Fluke 80I-110S 100 Amp DC 70 Amp AC Current Probe

Fluke 80I-110S 100 Amp DC 70 Amp AC Current Probe
Manufacturer: Fluke
Call for pricing
Fluke 80I-110S 100 Amp DC 70 Amp AC Current Probe


Fluke 80I-110S 100 Amp DC 70 Amp AC Current Probe

Rent me for $75 a month

   Accurate current measurements become more and more critical when troubleshooting electric, electronic, and automotive circuits. The Fluke 80i-110s AC/DC Current Probe is designed to provide you with safe, high accuracy measurements for a wide range of applications. The specially designed built in safety features such as the 600 V rms rating at the input jaws, output cable, and BNC connector enhance work safety n industrial and commercial power distribution systems.

   The probe is shielded for high noise immunity, to prevent unwanted noise when troubleshooting around noise generating devices like adjustable speed motor drives and ignition systems. The Fluke 80i-110s accurately reproduces current waveforms as they occur. Connect the clamp to a Fluke ScopeMeter Test Tool or other waveform recording device like a Fluke Power Harmonics Analyzer, to clearly see distorted waveforms that result from non-linear loads such as computers, adjustable peed motor drives, and electronic ballasts for fluorescent lighting. Current clamps, not specifically designed for oscilloscopes may add distortion to the actual signal present in the system under test. This makes it difficult to get an accurate waveform measurement.

   The wide measurement range from 50 milliamps to 100 Amps with a high fidelity millivolt output gives you full advantage of the high resolution oscilloscope displays. This gives you the true picture of your current situation, and allows useful measurements as low as 10 milliamps. The broad band frequency response of the Fluke 80i-110s AC/DC Current Probe from dc to 100 kHz supports a wide range of applications where the probe can be used. The probe can be used to track down leakage currents discharging car batteries or to measure dc currents Supply (UPS), that uses a battery backup system. With its narrow jaw design, the Fluke 80i-110s makes it easy to take measurements in tight spots.

  The Fluke 80I-110s is compatible with any Fluke ScopeMeter Test Tool, Power Harmonics Analyzer, Oscilloscope, Multimeter, or other voltage measurement device that has the following features: BNC input connectors or if using a meter convert the banana plugs to a BNC connector using the adapter PM9081/001.


  • Current Range: 0.1 to 100A DC or 0.1 to 70A AC
  • Basic Accuracy (DC to 1kHz):
    100mV/A setting: 50mA to 10A +/- 3% of reading + 50mA
    10mV/A setting: 50mA to 40A +/- 4% of reading + 50mA
    40A to 80A +/- 12% of reading + 50mA
    80 to 100A +/- 15% of reading
  • Output Signal: 10A range: 100mV/A | 100A range: 10mV/A
  • Bandwidth: 1Hz to 20kHz
  • Working Voltage: 600V AC rms
  • Maximum Conductor Size: 11.8 mm (.46 inch) diameter
  • Safety Rating: IEC 1010 and CSA-C22.2 No. 1010-1 Installation Category II, Working Voltage 600V