Anritsu Coaxial Waveguide Calibration Kit 5.85-8.2 GHz

Anritsu Coaxial Waveguide Calibration Kit 5.85-8.2 GHz
Manufacturer: Anritsu
Call for pricing
Anritsu Coaxial Waveguide Calibration Kit 5.85-8.2 GHz

 

Anritsu Coaxial Waveguide Calibration Kit 5.85-8.2 GHz

Rent me for $200 a month

with options

  • 26UA137 Precision Load
  • 35UA137N Coaxial Adapter, N(m) 5.85 to 8.20 GHz
  • 24UA137 3/8 Offset Short
  • 26UA137 Precision Low Power Termination

   This kit is designed to be used with Anritsu Sitemaster measurement products to adapt and calibrate them to properly measure back reflection in coaxial waveguides. The kit consists of a Type N to Waveguide adapter and the Shorts and Loads to calibrate the connection. The frequency range of these adapters is 5.85 to 8.2 GHz. Your Anritsu Sitemaster must be able to measure the range of 5.85 to 8.2 GHz. Outside of this frequency range different adapters must be used.

Question:

   Why don't I use an Open/Short/Load procedure for waveguide calibrations?

Answer:

   The waveguide calibration uses a 1/8 wavelength offset short, a 3/8 wavelength offset short and a precision waveguide load for calibration. For coax calibration the open and short both causes high reflections back to the Site Master but an open on a waveguide causes minimal reflections to occur although they are about twice as much as the load. The 1/8 and 3/8 offset shorts are used to set the 0 (zero) reference of the Site Master just like the Open/Short for coaxial calibrations.

US-Instrument.com